Shop By Vehicle
Year
Make
Model
Body
Engine

aFe Power

aFe Power Air Intake Systems, Exhaust Systems, Headers, Intercoolers, Turbochargers, Programmers, Torque Converters and more

 

Advanced FLOW Engineering (aFe Power) is a premier designer and manufacturer of automotive performance upgrade systems and components. Current product lines include cold air intake systems, high performance direct fit and racing air filters, exhaust systems, headers, intercoolers, turbochargers, electronic programmers, diesel fuel systems, torque converters, throttle body spacers, and more. aFe is passionate about providing the most compelling, innovative, and highest performing products that are designed, built, and tested in the USA. aFe was founded in 1999 and has headquarters and manufacturing facilities in Corona, California, USA. Accesspeed has been supplying aFe products to our customers since we opened our doors, and we are proud to offer the wide selection of aFe Power parts and accessories.


Air Intake and Induction » Mass Air Flow Sensors

What is a Mass Air Flow Sensor or MAF?

The mass air flow (MAF) sensor is part of your vehicle's electronic fuel injection system. The MAF sensor calculates the total amount of air entering the engine through the intake tract, and tells the computer how much fuel to inject for air coming through the intake. 

 

 

How does a mass air flow sensor work?

The mass air flow (MAF) sensor has two sensing wires in the housing that protrudes into the intake tube prior to the throttle body.  One wire is heated by electrical current, the other is not heated at all.  As air flows across the heated wire, it cools the wire down. When the temperature difference between the two sensing wires changes, the MAF sensor automatically increases or decreases the current to the heated wire to compensate, telling the computer how much fuel to send through the fuel injectors.

 

How much horsepower and mpg increase can I expect from an aftermarket mass air flow sensor?

Aftermarket performance mass air flow (MAF) sensors replace your OEM sensor and improve on mileage and can increase horsepower by up to 20-HP, depending on the vehicle and engine. Performance MAF sensors increase airflow and low-end torque, without robbing top-end power, and works with factory electronics.

 

What are the symptoms of a bad mass air flow (MAF) sensor?

  • The engine hesitates or drags while under load or idling.
  • During acceleration, you experience hesitation and jerking.
  • The engine coughs, sputters, or hiccups.
  • Excessively rich idling or lean idling.
  • The engine is difficult to start or crank over.
  • The engine stalls or dies shortly after starting.

 

Can you drive with a bad mass air flow sensor?

Yes and no. Yes, you can drive your vehicle with a bad mass air flow (MAF) sensor, but only to get it home or to a repair shop to fix or replace it. Ignoring this problem can lead to far more severe engine problems and damage.

 

Why would a car run better with the mass air flow sensor unplugged?

If your vehicle runs better with your MAF sensor unplugged, you likely have a shorted-out sensor. When the computer does not read a signal from your mass air flow sensor, it provides the computer with a stock signal that will allow you to drive your vehicle for a short period of time to get it fixed or replaced.