RAM billet steel flywheels are recommended as a replacement for fac
There is a difference in aftermarket flywheels! RAM billet flywheelsare produced completely in house using computer controlled equipment to provide you with a flywheel that is properly machined within .001 tolerances, surface ground to allow the best mating friction surface for the disc to seat against and guard against runout, and precision balanced on a computer controlled balancer to within ½ oz/in of the factory balance specification. In other words, a RAM billet flywheel is ready to run right out of the box. Be sure you are getting these features on the flywheel you select!
All billet flywheels are not created equal! Make sure you are getting the features you pay for. RAM billet steel and aluminum flywheels are fully machined and assembled in house. That means when you get your RAM billet flywheel, it is already surface ground, already balanced, and ready to install out of the box. A key feature of RAM aluminum flywheels is the steel insert. A flywheel insert must have enough mass to wick heat away from the clutch without distorting. RAM uses a .250-inch thick inset that is riveted in before the flywheel is surface ground. This assures a parallel friction surface with no run out, and enough material to adequately wick the heat while maintaining flatness over time that thinner inserts simply cannot do. All RAM billet flywheels are SFI certified.